Table of Contents
Advertisement
4.5 Converter Status
The page shows the converter's copper and fiber linking status. The screen in Figure 4-11 appears.
The page includes the following fields:
• Ports
• Signal detect(SD)
• Link Status
• Duplex mode
• Flow Control
• Speed
• Auto negotiation
Figure 4-11 Converter Status page screen
Indicate the Copper port and Fiber port
Shows the current signal detect status of the fiber and TP ports.
For example, if a fiber signal is detected, it shows Detected. Else shows No.
The state of the link, indicating a valid link partner device. "Up" means a device is
successful connected to the port. "Down" means no device is connected.
The port duplex mode, Full (transmission occurs in both directions
simultaneously) or Half (transmission occurs in only one direction at a time). This
mode can be configured only when auto-negotiation is disabled and port speed is
set to 10Mbps or 100Mbps.
Shows the flow control status of the port. It is active when the port uses Full
Duplex Mode
Shows the connection speed of the port and the speed can be configured only
when auto-negotiation is disabled on that port
This is the current setting of the port's Auto Negotiation feature
-24-
Advertisement
Table of Contents
