Integrated Peripherals - ECS G31T-M7 Manual

Integrated Peripherals

This page sets up some parameters for peripheral devices connected to the system.
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
Onboard IDE Controller
OnBoard SATA Controller
Onboard LAN Function
Onboard LAN Boot ROM
Onboard AUDIO Function
Serial Port1 Address
Parallel Port Address
Parallel Port Mode
ECP Mode DMA Channel
Parallel Port IRQ
USB Functions
Legacy USB Support
: Move
F1:General Help
Onboard IDE Controller (Enabled)
Use this item to enable or disable the onboard IDE interface.
OnBoard SATA Controller (Enhanced)
This item allows you to enable or disable the onboard SATA controller.
Onboard LAN Function (Enabled)
Use this item to enable or disable the onboard LAN function.
Onboard LAN Boot ROM (Disabled)
Use this item to enable or disable the booting from the onboard LAN or a network
add-in card with a remote boot ROM installed.
Onboard AUDIO Function (Enabled)
Use this item to enable or disable the onboard audio device.
Serial Port1 Address (3F8/IRQ4)
Use this item to enable or disable the onboard COM1 serial port, and to assign a port
address.
Parallel Port Address (378)
Use this item to enable or disable the onboard Parallel port, and to assign a port
address.
Parallel Port Mode (ECP)
Use this item to select the parallel port mode. You can select Normal (Standard
Parallel Port), ECP (Extended Capabilities Port), EPP (Enhanced Parallel Port), or
BPP (Bi-Directional Parallel Port).
ECP Mode DMA Channel (DMA3)
Use this item to assign the DMA Channel under ECP Mode function.
Integrated Peripherals
Enabled
Enhanced
Enabled
DISABLED: disables the in-
Disabled
tegrated IDE
Enabled
controller.
3F8/IRQ4
ENABLED: enables both
378
Controllers.
ECP
DMA3
IRQ7
Enabled
Enabled
Enter : Select +/-/: Value F10: Save ESC: Exit
F9: Load Default Settings
Using BIOS
33
Help Item