Front Panel Display - Yamaha RX-Z9 Owner's Manual

I_'i "J.Vil :l_ lO] ".,tl [O]_v_ "
• Volume Trim (Volume trim)
Use this feature to adjust the level of the signal input to
each jack. This is useful if you want to balance the level of
each input source to avoid sudden changes in volume
when switching between input sources.
Input Select > input source (DVD, etc.) > Volume Trim >
Control range: 45.0 to +6.0
• Assign (Assign)
You can assign the digital audio input/output and
component video jacks to other components if this unit's
initial settings do not correspond to your needs. Change
the following parameters to reassign the jacks and
effectively connect more components.
Once the jacks are reassigned, you can select the
corresponding component using INPUT SELECTOR on
the front panel or the input selector buttons on the remote
control.
Input Select > input source (DVD, etc.) > Assign >
Example 1:
To assign the COAXIAL @ (DTV/LD) jack to the DVD
input.
1) Select Input Select, then select DVD.
2) Select Assign > Coaxial Input, then select @ DTV/LD.
Example 2:
To clear a jack assignment.
l) Select Input Select, then select the input source (DVD,
etc.).
2) Select Assign, then select the jack assignment (Coaxial
Input, Optical Input, Optical Output or Component
Video).
3) Select None, then press ENTER to clear the
assignment.
• Rename (Rename)
Use this feature to change the name of the inputs on the
GUI and front panel display. (DVD is used as the source
component in the following example.)
Input Select > input source (DVD, etc.) > Rename
1
Press an input selector button to select the
input you want to change the name of.
2 Press <1/ D to place the_ (under-bar) under
the space or character you want to edit.
Press ENTER to select a character type
(CAPITAL/SMALL/FIGU RE/MAR K).
Press/_/V to select the character you want to
use and <1 / [> to move to the next one.
• You can use up to 8 characters for each input.
• Press V to change the character in the following
order, or press A to go in the reverse order:
AtoZ, 0to9, atoz, #, *, +, etc.
• Repeat steps 1 to 3 to rename each input.
Select the OK button and press ENTER when
complete.
• You cannot select a specific item more than once for the same
type of jack.
• When you connect a component to both the COAXIAL and
OPTICAL jacks, priority is given to the input signals from the
COAXIAL jack.
• If you want to use the COAXIAL @ (DTV/LD) jack to input
Dolby Digital RF signals, assign the DTV/LD input source to
the Coaxial Input (@ DTV/LD), then press C> to select @ LD-
RF.
66