Assembling The System; Assembling The Projection Frame (Rmf-V4011/V5011) - Pioneer RM-V2400NA Technical Manual

4. ASSEMBLING THE SYSTEM

(1) Assembling the Projection Frame (RMF-V4011/V5011)

Assemble the projection frame as follows.
[1] Mount the stopper onto the base assembly and tighten the screws (M5
[2] Mount the H-shape frame assemblies (R) and (L), and tighten the screws (M5
[3] Mount the horizontal frame assemblies (two) and tighten the screws (M5
* As for the positions for tightening the screws in steps [2] and [3], push the frame against the corner fixtures in the two
directions indicated by the arrow.
[4] Attach the shield to the H-shaped frame assembly (L) using rivet, and paste the magic tape on the H-shaped frame
assembly (L) according to the magic tape pasted on the shield.
[5] Attach the fixtures (R) and (L) and tighten the screws (M5
[6] Place the projection unit on the base assembly, and secure the fixtures (R) and (L) and projection unit to each other with
the screws (M5 10). (2
[7] Secure the movable part of the base assembly with the two screws (M5
H-shape frame assembly (L)
5 Shield
2 H-shape frame assembly (L)
1 Screw (M5
2 points)
3 Horizontal frame assembly
4 Rivet
35)
1 Stopper
(Fig. 3-19)
INSTALLATION AND ASSEMBLY
35). (2
10). (4
10). (4
10). (3 2 points)
35).
A-5
Holder (L)
2 H-shape frame
assembly (R)
Table
1 Base assembly
2 points)
4 points)
4 points)
A-7
B-6
Screw (M5
A-5 Holder (R)
B-5 Guide fixture
35)
45