General Specifications - Pioneer RM-V2400NA Technical Manual

No. Name
1
ABL link switch
2
Linked input terminal
3
Linked output terminal
4
Remote control connection ter-
minal
5
RS-232C port
6
Control input terminal
7
Y (Luminance) input terminal
8
C (Color) input terminal
9
Video input terminal
0
Video output terminal
-
TERMINATE switch
=
COMBINATION switch
~
MULTI switch
!
COLOR MODE switch
@
INPUT switch
#
POWER switch
$
STATUS switch
%
RGB input terminal
^
RGB input select switch
&
RGB input terminal (Vertical sync)
*
RGB input terminal
(Horizontal sync/composite
sync)
(
RGB input terminal (B)
)
RGB input terminal
(G/composite sync)
_
RGB input terminal (R)
• To turn off the power, use the POWER switch - of the unit, the RS-232C control, or wired remote control (optional). (If turned
off using the main POWER switch or by disconnecting the power cable from the outlet, the settings of the above = to @
switches and the state of the TV SYSTEM and convergence memory will not be recorded on the memory.)
Consequently when starting up or stopping the whole system by AC ON/OFF in setup conditions for a demonstration, it is
necessary to turn off the power using the above method to record each setting in the memory.
(Refer to "CHAPTER 4. ADJUSTMENTS, (5)Equipment Required for Adjustments".)
* : Accumulated duty time
Counts only when the power is ON.
Type
Slide switch Used for switching the control level of the ABL link control voltage
when ABL link is ON.
DIN 6PIN Input terminal of ABL signal, remote control signal and RS-232C
signal
DIN 6PIN Output terminal of ABL signal, remote control signal, and RS-232C
signal
Mini jack Connected to adjusting remote control (optional)
D-sub 25 PIN (Female) RS-232C communication connector
BNC connector Video input and Y/C input external switching control signal input
terminal
BNC connector Luminance signal input terminal
BNC connector Color signal input terminal
BNC connector Video signal input terminal
Video input terminal 9 through-out terminal
BNC connector
Turns on when terminates the video input terminal 9 at 75 ohm
Slide switch
Tact switch Turns on when linked to ABL
Tact switch Turns on when used on multi screen
Tact switch Switches the color temperature. 1:Normal use. 2:Re-exposure
Tact switch Switches VIDEO input, Y/C input, RGB input.
Switches VIDEO input and Y/C input with the external control signal
6 at VIDEO position
Tact switch Power OFF : STANDBY (Red LED) lights up
Power ON : ON (Green LED) lights up
Tact switch Accumulated duty time: * Switch which displays setting states of
each switch on the screen.
D-sub 9PIN (Male) RGB signal input terminal
Slide switch Switches RGB signal input terminal type
BNC connector RGB signal vertical sync input terminal
BNC connector RGB signal horizontal sync and composite sync (Only for input sig-
nal H/V sync) input terminal
BNC connector RGB signal B input terminal
BNC connector RGB signal G and composite sync (Input signal G on sync) input
terminal
BNC connector RGB signal R input terminal

GENERAL SPECIFICATIONS

Function
Normal(video signal input) : Open
Select Y/C input : Low(0V)
9