Download Print this page

Troy-Bilt 30247 Operator's Manual page 4

Briggs & stratton
Hide thumbs Also See for 30247:

Advertisement

Available languages

Available languages

Section 1: Safety Rules
WARNING
DO NOT touch hot surfaces and avoid hot exhaust gases.
Allow equipment
to cool before touching.
Keep at least 5 ft. (152 cm) clearance on all sides of generator
including overhead.
Code of Federal Regulation
(CFR) Title 36 Parks, Forests, and
Public Property
require equipment
powered
by an internal
combustion
engine to have a spark arresten maintained
in
effective working
order, complying
to USDA Forest service
standard SI00-IC
or later revision. In the State of California
a
spark attester
is required
under section 4442 of the California
Public resources
code. Other
states may have similar laws.
WARNING
WHEN
ADJUSTING
OR MAKING
REPAIRSTOYOUR
GENERATOR
Disconnect
the spark plug wire from the spark plug and place
the wire where it cannot contact
spark plug.
WHENTESTING
FOR ENGINE
SPARK
Use approved
spark
plug tester.
DO NOT
check for spark with spark
plug removed.
CAUTION
DO NOT tamper with governed
speed. Generator
supplies
correct
rated frequency
and voltage when running at governed
speed.
DO NOT modify generator
in any way.
CAUTION
See "Don_t
Overload
Generator".
Start generator
and let engine
stabilize
before
connecting
electrical
loads.
Connect
electrical
loads in OFF position,
then turn ON for
operation.
Turn electrical
loads OFF and disconnect
fl'om generator
before
stopping
generator.
CAUTION
Use generator
only for intended uses.
If you have questions about intended use, ask dealer or call
1-888-61 1-6708.
Operate
generator
only on level surfaces.
DO NOT expose generator
to excessive moisture, dust, dirt,
or corrosive
vapors.
DO NOT insert any objects through cooling slots.
If connected
devices overheat, turn them off and disconnect
them from generator.
Shut off generator
if:
-electrical
output
is lost;
-equipment
sparks,
smokes,
or emits flames;
-unit vibrates
excessively.
O

Advertisement

loading