Troy-Bilt CSV 060 Operator's Manual page 12

3.
4.
5.
f
Grasp bag handle with one hand and pull lock rod on
mounting bracket with other hand toward engine to
release.
Lift bag off back of unit.
Twist the two buttons on the back of the bag to unlock and
empty contents. SeeFig. 5-3. Hold bag handle and bag clip
while emptying the contents.
Buttons
Outer Flap ................. -_
inner
Flap
Figure 5-3
6.
7.
8.
Compress bag opening and fold inner flap over opening.
Fold outer flap over inner flap and insert buttons on the bag
through metal outlets. See Fig. 5-3.
Twist the buttons to lock bag. Place bag back onto unit as
instructed in Assembly & Set-Up.
WARNING: Do not at any time make any
adjustments without first stopping engine and
disconnecting spark plug wire.
UsingTheNozzleVacuum
Yard waste such as leaves and pine needles can be vacuumed
up through the nozzle for shredding. After material has been
shredded by the flail blades on the impeller assembly, it will be
discharged into catcher bag. Do not attempt to shred or chip
any material other than vegetation found in a normal yard (i.e.
branches, leaves, twigs, etc.) Avoid fibrous plants such as tomato
vines until they are thoroughly dried out. Materials such as stalks
or heavy branches up to 1 1/2" in diameter may be fed into the
chipper chute.
1. Place nozzle/hose vac lever in the top position on the
nozzle to vacuum through nozzle. See Fig. 5-4.
f
Figure 5-4
2. The spring loaded pin must be in the first hole (closest to
the end of the tube) of the hose adapter to operate the
nozzle vac. See Fig. 5-4.
3. Place both hands on top of upper handle to push unit over
yard waste.
_ WARNING: Do not attempt to shred, chip, or
vacuum any material larger than specified on the
machine or in this manual. Personal injury or
damage to the machine could result.
IMPORTANT:The flail screen is located inside the housing in
the discharge area. If the flail screen becomes clogged, remove
and clean as instructed in Maintenance & Adjustments. For best
performance, it is also important to keep the chipper blade
sharp.
12 I
SECTION 5-- OPERATION