Understanding Built-In Cd Player Error Messages; Understanding Built-In Md Player Error Messages - Pioneer FH-P8900MD Owner's Manual

Additional Information
U
nderstanding built-in CD player error messages
When problems occur during CD play, an error message may appear on the display. If an error mes-
sage appears on the display, refer to the table below to see what the problem is and the suggested
method of correcting the problem. If the error cannot be corrected, contact your dealer or your near-
est Pioneer service center.
Display
ERROR- 11, 12, 17, 30
ERROR- 11, 12, 17, 30
ERROR- 14
ERROR- 10, 11, 12, 14,
17, 30, A0
ERROR- 44
HEAT
U
nderstanding built-in MD player error messages
When problems occur during MD play, an error message may appear on the display. If an error mes-
sage appears on the display, refer to the table below to see what the problem is and the suggested
method of correcting the problem. If the error cannot be corrected, contact your dealer or your near-
est Pioneer service center.
Display
BLANK DISC
TEMP
ERROR- 11, 12, 17, 30
ERROR- 11, 12, 17, 30
ERROR- 01, 11, 12, 17,
30, A0
ERROR- 20, 21
ERROR- 20, 21, 24
ERROR- 23
ERROR- A1
ERROR-
47
Cause
Dirty disc.
Scratched disc.
Unrecorded disc.
Electrical or mechanical
problem.
All tracks are skip tracks.
CD player overheated.
Cause
Blank disc is inserted.
MD player overheating.
temperature drops.
Dirty disc.
Scratched disc.
Electrical or mechanical
problem.
Track information cannot be
read.
There is something wrong with
the MD.
The MD contains recorded
information other than music.
Electrical or mechanical
problem.
MD play not possible.
Remedy
Clean disc.
Replace disc.
Check the disc.
Turn the ignition ON and OFF, or
switch to a different source, then
back to the CD player.
Replace disc.
Turn off the CD player and wait
until the CD player cools down.
Remedy
Replace disc.
Discontinue play until the machine
Clean disc.
Replace disc.
Turn the ignition ON and OFF, or
switch to a different source, the
back to the MD player.
Reload the MD.
Replace disc.
Replace disc.
Press RESET.
Replace the MD with another disc,
or press RESET.