Table of Contents
Advertisement
Configuringthe antenna input
source for the ANT/CABLE terminal
1
From the SETUP menu, highlight ANT/CABLE In.
2
Press
_
or •
to select the input source (Antenna or
Cable) for the ANT/CABLE input and press _.
Programmingchannels into the
TV's channel memory
When
you press
(_ or _j on the remote
control
or TV
control
panel,
your TV will stop only on the channels
you programmed
into the TV's channel
memory.
Follow
the steps below
to program
channels
into the
TV's channel
memory.
Auto Tuning
Your TV can automatically
detect
all active channels
in
your area and store
them in its memo1T.
After the
channels
are programmed
automatically,
you can
manually
add or erase
individual
channels
in the
channel
memory.
Note:
• You must configure the ANT/CABLE input source before
programming
channels.
° If the ANT/CABLE input is configured
for Cable, the
automatic channel programming
process
erases
channels that were previously programmed
into the TV's
memory.
° If the ANT/CABLE input is configured
forAntenna,
the
automatic channel programming
process
adds newly
found channels to the existing set of programmed
channels (and does NOT erase channels that were
previously
programmed
into the TV's memory).
To
remove an Antenna source channel from the memory,
you must set it to Skip (_,_ "Setting channel skip" on page
36).
° To tune the TV to a channel not programmed
in the
channel memory, you must use the number buttons on
the remote control
• Programming
channels when the ANT/CABLE
input is
configured
for Cable will take substantially
longer than
when the antenna input is configured
for Antenna.
This
is normal; however, once channel programming
is
finished, you should not have to repeat the programming
process
again unless your Cable TV service lineup
changes significantly.
1
Configure
the ANT/CABLE
input,
if you have not
already
done
so (_'
left-hand
column).
2
From the SETUP
menu,
highlight
Auto Tuning
and
press
_.
3
A screen
will appear
warning
that previous
programs
and settings
will be deleted.
4
Press _
to start Auto
Tuning.
The TV will automatically
cycle through
all the
channels,
and store
all active channels
in the
channel
memory.
When
Auto Tuning
is finished,
press
(_ or _j to view
the programmed
channels.
Manual Tuning
After automatically
programming
channels
into the
channel
memory,
you can manually
enter
channels
if
the physical
channel
is known.
1
From the SETUP menu, highlight Manual Tuning
and press _.
Use the Channel Numbers
on the remote control to
enter the channel number (up to three-digit
number) and press (o_.
Press _) to start Manual Tuning.
If channels
are found,
they will be listed
at the bottom
of the screen.
Analog
channels
will be noted
by an
"ATV"
symbol
and digital
channels
by a "DTV"
symbol.
35
- Quick Links:
- Tv Back Panel
Hide quick links:
Advertisement
Table of Contents
