Programming The Remote Control To Operate Your Other Devices - Toshiba 55UX600U Owner's Manual

Programmingthe remote control
to operate your other devices
Your Toshiba TV remote control is preprogrammed to
operate most Toshiba devices. To program your TV
remote control to operate a non-Toshiba device (or a
Toshiba device that it is not preprogrammed to
operate), follow the steps below. For details on using
the remote control to operate the device, see page 25.
2
3
4
5
6
In the remote control code table (_ pages 29-31),
find the code for your device. If more than one code
is listed, try each one separately until you find one
that works.
Set the MODE SELECT switch to the type of device
you are programming the remote control to operate
-- CABLE/SAT (for a cable converter box or
satellite receiver), DVD (for a DVD player, HTIB
[home theater in a box] or BD), or AUX (for a VCR
or TV/VCR combo).
While holding down 8, press the Channel Number
buttons to enter the 3-digit code for your device.
To test the code, turn on the device, point the
remote control at it, and press P%ERSee notes below.
• If the correct code was entered, the device will turn
off.
• If the device does not respond, repeat steps 1 - 4
using another code.
• If the device does not respond to another code, you
will need to use the remote control that came with
the device.
Remember to set the MODE SELECT switch back to
"TV" to control the TV.
For future reference, write down the code(s) you
used:
Note:
• In addition to POWER, confirm that all necessary keys on
the TV remote control operate your device. If some keys
are not operational repeat the device code setup using
another code (if other codes are listed for your device).
If, after trying all listed codes, the necessary keys do not
operate your device, use the device's original remote
control
• Every time you change the batteries, you will need to
reprogram the remote control.
• Some newer VCRs respond to either of two codes. These
VCRs have a switch labeled "VCR 1/VCR2. " If your VCR
has this kind of switch and does not respond to the
codes for your VCR brand, set the switch to the other
position ("VCR1" or "VCR2") and reprogram the remote
control.
28