How To Handle - Toshiba Carrier TCB-AX21UL Owner's Manual

Wireless remote controller kit Owner's Manual
7
HOW TO HANDLE THE REMOTE
CONTROLLER
• Direct the transmitter of the remote controller toward the sensor (indoor unit body)
When the signal is normally received, "Pi" sound is heard once.
("Pi, pi" sounds are heard only when the operation has started.)
• The standard distance which the signal can be received is approx 23' (7m)
The distance differs a little according to the capacity of the battery, etc
• Be careful there is not something to block the signal between the sensor (indoor unit body)
and the remote controller
• Do not put the remote controller on the place exposed to the direct sunlight or air from the
air conditioner or near the stove, etc
• Do not drop, throw, or clean with water the remote controller
• The signal may be accepted in a room where the electronic instantaneous-ON type or
inverter type florescent light is set For details, contact the shop which you purchased the
air conditioner
• To Use the Remote Controller Setting to Wall, etc.
• Check a signal is received correctly by pushing (I._ ON/OFF button at the position to be
fixed.
• To take off remote controller, pull it toward you.
Setting method of
remote controller
Fix the remote controller
holder with the screws.
Mounting screw
Truss tapping
/
Remote controller holder
-13-