How To Use The Remote; Address - Toshiba Carrier TCB-AX21UL Owner's Manual

Wireless remote controller kit Owner's Manual
8
HOW TO USE THE REMOTE CONTROLLER
CORRECTLY
• Set the remote controller so that it is not excessively far from the signal receiving
unit, otherwise a malfunction is caused.
Be sure to set the remote controller in the same room where the signal receiving unit is
installed.
• Direct the remote controller toward the signal receiving unit for operation.
When a signal is correctly received, "Pi" sound can be heard.
• Avoid to set the remote controller at a place where it is covered with curtain, etc.
9
ADDRESS
When the multiple indoor units corresponding to the wireless remote controller are
installed in the same room, an address can be set up to prevent an interference.
Matching the address switch of the signal receiving unit with number of the remote
controller address, Max. 6 indoor units can be controlled by the corresponding remote
controller individually. For the seventh indoor unit onwards, address setting is
necessary from wired remote controller.
The address switch for receiving the signal is prepared to the signal receiving unit and
the address switch for sending the signal is prepared to the remote controller. For
details, contact the shop which you purchased the air conditioner.
• How to Check the Address
When pushing _ button on the remote controller, the present address is displayed on the
display section of the remote controller. If this address matches with the address of the signal
receiving unit, a buzzer sounds.
(When ALL is displayed, buzzer sound is necessarily heard.)
When ALL is displayed, the air conditioner can be operated regardless of any address of the
signal receiving unit. Send the signal by directing the remote controller toward the signal
receiving unit to be handled.
- 14 - f4-EN