Pushing The Machine; By Hand - Toro TimeCutter Z4220 Operator's Manual

,
Move file bypass levers rearward and tllen down
to lock them in place as shown in Figure 21 to
disengage the wheel motors Repeat this on each
side of the machine
5, Move the motion control levers inward to tile
neutral position
The machine is now able to be pushed by hand..
\
\
1 ContrN arm shaft
2, Control lever
Figure 20
3. Slotted, upper hole
4. Bolt
.3,, Repeat the adiustment for the opposite control
lever,
Adjusting the Tilt
The motion control levers can be tilted fore or aft for
maxqmum operator comfort
I Loosen the upper bolt holding the control lever to
the control arm shaft..
2o Loosen the lower bolt just enough to pivot the
control lever fore or aft _igure 20)_. Tighten both
bolts to secure the control in the new position.
3.. Repeat the adjustment for the opposite control
lever,,
2
Figure 21
Right side shown
1 Bypass lever location 3, Lever position for
operating the machine
2 Lever position for pushing
the machine
To Operate the Machine
Move the bypass levers upward and push them forward,
to the middle of the horizontal slot (Figure 21) to
engage the wheel motors..
Pushing the Machine by Hand
Important:
Always push the machine by hand.
Never tow the machine because damage may
OCCUlt'.
To Push the Machine
1., Park the machine on alevd surface and disengage
the blade control switch.
2. Move the motion control levers outward to park
position, stop the engine, remove the key, and wait
for al! mo,dmg parts to stop before leaving the
operating position_
3. Locate the bypass levers at the rear of the machine,
on the left and right side of the frame.
21