Toro TimeCutter Z4220 Operator's Manual page 38

,
.
Figure 49
Mower Decks with 2 Blades
1, Blades front to rear
2 Measure from the tip of the blade to the flat surface here
3 2
Figure 50
Mower Decks with 3 Blades
I,. Btades front to rear
2, Outside cutting edges
3 Measure from the tip of the
blade to the flat surface
here
Measure from the tip of the front blade to the flat
surface and the tip of the rear blade to the flat surface
(Figure 49 and Figure 50) If the front blade up is
not 1/16-5/16 inch (i .6-7_9 ram) lower than the rear
blade tip, adjust the front loctmut,.
To adjust the front-to-rear blade slope, rotate the
adjustment nut in the front of the mower (Figure 5 !).
i
G005075
1o Adjusting rod
2,, Adjusting block
Figure 51
3 Locknut
7. To rise the front of the mower, tighten the
adjustment nut. To lower the front of the mower,
loosen the adjustment nut.
8. After adjustment, check the front-to-rear slope again.
Continue adjusting the nut until the front blade tip
is !/16-5/16 inch (1.6-7.9 ram) lower than the rear
blade tip (Figure 49 and Figure 50),.
9. When the front-to-tea blade slope is correct check
the side-to-side level of the mower again; refer to
Leveling the Mower from Side-to-Side
Removing the IViower
1. Park the machine on a level surface and disengage
the blade control switch.
2. Move file motion control levers outward to the
park position, stop the engine, remove the key, and
wait for all moving parts to stop before leaving file
operating position.
3. Lower the hight-of-cut lever to the lowest position.
4,. Remove the hairpin cotter and clevis pin from the
front support rod (Figure 52)_ Carefully lower the
front of file mower de& to tBe ground,.
38