Engine Maintenance; Servidng The Air Cleaner - Toro TimeCutter Z4220 Operator's Manual

,
Connect a grease gun to eac!_ fitting (Figure 2.3 and
Figure 24).. Pump grease into the fittings until grease
begins to ooze out of the bearings
5. Wipe up any excess grease.
Engine Maintenance
Servicing the Air CJeaner
Service Interval: Before each use or daily---Check the
air cleaner for dirty, loose or damaged
parts.
This engine is equipped with a replaceable, high density
paper air cleaner element_ Check the air cleaner daily or
before starting the engine. Check for a buildup of dirt
and debris around the ,'fir cleaner system Keep Otis area
dean. Also check for loose or damaged components,
Replace a!l bent or damaged air cleaner components..
Note:
Operating the engine with loose or damaged air
cleaner components could allow unfiltered air into the
engine causing premature wear and failure
Note: Sen'ice the air cleaner more often under
extremdy dusty, dirt3, conditions
1_ Knobs, air cleaner cover
2, Air cleaner cover
3_ Paper element
4 Air creaner base
Servicing Paper Element
Service Interval: Every 25 hours--Service the paper
dement. (more often under extremely
dusty, dirty conditions)
Every 100 hours--Replace the paper
dement. (more often under extremdy
dusty., dirty conditions)
1. Remove the air cleaner cover (Figure 25)..
Z Remove the air cleaner element with the integral
rubber seal (Figure 25),
.3. Gently tap the pleated side of the paper dement to
dislodge dirt. Do not wash the paper dement or
use pressurized air, as this xx6_tl d amage the element.
26