Table of Contents
Advertisement
Conformity
and Compliance
FCC Compliance
Statement
This equipment
has been tested and found to comply with the limits for a Class B digital
device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable
protection
against harmful
interference
when the equipment
is operated
in a residential
installation.
This
equipment
generates,
uses, and can radiate radio frequency
energy and, if not installed and used
in accordance with the instructions,
may cause harmful
interference
to radio communications.
However, there is no guarantee
that interference
will not occur in a particular
installation.
If this
equipment
does cause harmful
interference
to radio or television
reception
(this can be
determined
by turning
the device off and on), the user is encouraged
to try to correct the
interference
by one or more of the following
measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation
between the equipment
and the receiver.
•
Connect the equipment
to an outlet on a circuit different
from that to which the receiver
is connected.
•
Consult the dealer or an experienced
radio/TV technician
for help.
Caution:
To comply with the limits for an FCC Class B computing
device, the user should use the shielded
signal cable and power cord supplied with the unit. The FCCwarns that changes or modifications
of the unit not expressly approved
by the party responsible for compliance
could void the user's
authority
to operate the equipment.
Radio
Frequency
Interference
Statement
Warning:
This is a Class B product.
In a domestic environment
this product may cause radio interference,
in
which case the user may be required to take adequate
measures.
Canadian
DOC Notice
for Class B Computing
Devices
This digital
apparatus does not exceed the Class B limits for radio noise emissions from a digital
apparatus
as set out in the Radio Interference
Regulations
of the Canadian Department
of
Communications.
CE Marking
and Declaration
of Conformity
This device complies with the requirements
of related European standards, which include the
following:
Emission: EN 55022, EN 61000-3-2, EN 61000-3-3
Immunity:
EN 50082-1
Safety: EN 60950 Low-Voltage
Directive (73/23/EEC)
Advertisement
Table of Contents
