Installing Non-Combustible Facing Material - Heat & Glo Escape-42DV Owner's Manual

C. Installing Non-combustible Facing Material
WARNING
Fire Risk.
• Follow these instructions exactly.
• Facing materials must be installed properly to
prevent fi re.
• No materials may be substituted without
authorization by Hearth & Home Technologies.
• Center and attach two top boards to the framing
members. See Figure 9.2.
• Attach left and right side pieces to framing members.
• Use fasteners from fastener packet (in manual bag) in
shaded areas.
• Use regular sheetrock screws in non-shaded areas.
• Use a wet or dry towel or soft brush to remove dust or
dirt from facing material.
• Apply a non-combustible adhesive to attach tile,
stone or other non-combustible fi nishing materials per
manufacturer's instructions.
(9 IN. WIDE, SUPPLIED ATTACHED TO
NO FASTENERS
IN THIS AREA
Figure 9.2 Attaching Non-combustible Facing Material
NON-COMBUSTIBLE
FACING MATERIAL
BACK OF APPLIANCE)
9 IN.
2 IN.
1 IN.
APPLY FASTENERS
FROM FASTENER PACKET
IN THESE AREAS
Heat & Glo • Escape-42DV • 2052-900 Rev. Y • 11/11
NON-COMBUSTIBLE
ZONE
60 in.
Figure 9.3 Complete Installation of Non-combustible Facing
Material
43 in.
33