Step 5 Installing The Optional Heat-Zone-Gas Kit; Step 6 The Gas Control Systems - Heat & Glo 6000TR-OAK Owner's Manual

Step 5.
Installing the Optional Heat-Zone-Gas Kit
NOTE: There must be NO INSULATION or other com-
bustibles inside the framed firestop opening.
HEAT-ZONE-GAS
ATTACHES
HERE
Figure 32.
1. Remove the knockout from the fireplace and discard it
(see Figure 32).
2. Center the duct collar around the exposed hole and at-
tach it to the fireplace with 3 screws. NOTE: Do this BE-
FORE final positioning of the fireplace.
3. Determine the location for the air register/fan housing
assembly.
Reference the Heat-Zone-Gas kit instructions for the re-
maining installation steps.
28 Heat & Glo • 6000TR-OAK, 6000TR-OAK-IPI • 383-901 Rev. K • 5/06
Step 6. The Gas Control Systems
WARNING: THIS UNIT IS NOT FOR USE WITH
!
SOLID FUEL.
Two types of gas control systems are used with these models:
Standing Pilot Ignition and Intermittent Pilot Ignition (IPI).
Standing Pilot Ignition System
This system includes millivolt control valve, standing pilot,
thermopile/thermocouple flame sensor, and piezo ignitor.
! WARNING: 110-120 VAC MUST NEVER BE
CONNECTED TO A CONTROL VALVE IN A
MILLIVOLT SYSTEM.
Intermittent Pilot Ignition (IPI) System
This system includes a 3V control valve, electronic module
and intermittent pilot.
WARNING: CONTINUOUS 110-120 VAC SER-
!
VICE MUST BE WIRED DIRECTLY TO THE FIRE-
PLACE JUNCTION BOX.
STANDING PILOT
INTERMITTENT PILOT IGNITION
Figure 33. Gas Control Systems
3/8 in.
(10mm)
FLAME SENSOR
ROD