Table of Contents
Advertisement
PROBLEM
POSSIBLE
CAUSE
Unit does not operate
Unit is unplugged
Unit does not cool room
In dehumidifying mode, no
cool air coming out
"Water Full" indicator is
blinking
Noise or vibration
Water is leaking from unit
Drain bucket is full
Water bucket not installed
correctly
Air exhaust is clogged
Timer is on
There is a heating source in the
room
Temperature
setting is too high
Air filter is dirty
Air exhaust is not installed
correctly
Room is too big or too much
ambient sunlight is reaching
in
There is frost on the evaporator
There is frost on the evaporator
The water bucket is full
The water bucket is not
installed correctly
Surt:ace is not level
Surface is not level
Drainage plug is loose
REMEDY
Securely
plug receptacle
into
the power outlet
Empty water bucket
Completely
insert water bucket
Remove obstruction
from
exhaust hose
Cancel the timer
Turn down or off the other
heating source
Lower temperature
setting
Clean or replace the air filter
Check the exhaust
duct to
make sure that the hot exhaust
air is being vented out of the
room
This unit provides
spot cooling
or cooling tbr a room no larger
than 300 square feet with
standard
ceiling height
The unit will defrost
automatically
and return to
operation
afterwards
The unit will defrost
automatically
and will return to
operation
afterwards
Empty the water bucket
Completely
insert the water
bucket
Place unit on a level surt:ace
and away from obstructions
Place unit on a level surt:ace
Make drain tube is properly
secured and plugged
TECHNICAL
SPECIFICATIONS
17
Advertisement
Table of Contents
