Table of Contents
Advertisement
INSTALLING YOUR
DRIVE
This chapter guides you through the installation of
your new CD-ROM drive.
must have a free IDE interface connector, or you must
buy an IDE controller card from a computer retailer.
(An Enhanced IDE controller card is required if your
PC already has a one-port IDE controller).
Appendix A for a brief introduction to IDE
connections.
2.1 Installing the CD-ROM Drive
Here's how to install your CD-ROM drive:
1. Turn off your PC and remove its casing.
2. Adjust the Master/Slave jumpers on the back of the
CD-ROM drive as necessary.
of the slave mode normally should not be changed.
See Appendix A .)
3. Remove the 5.25" drive's drive guard as instructed
by your PC manual.
4. Slide the CD-ROM drive into the drive bay.
2
To install the drive, your PC
(The factory default
2
See
3
Advertisement
Table of Contents
