Tools Required - Poulan Pro PP4000C Instruction Manual

SPECIAL NOTICE: Exposure tovibrations
through prolonged use ofgasotine powered
hand tools could cause blood vessel or nerve
damage in the fingers, hands, and joints of
people prone to circulation disorders or abnor-
mal swellings. Prolonged use in cold weather
has been linked to blood vessel damage in
otherwise healthy people, if symptoms occur
such as numbness, pain, loss of strength,
change in skin color or texture, or loss of feel-
CARTON CONTENTS
ing in the fingers, hands, or joints, discontinue
the use of this toot and seek medical attention.
An anti-vibration system does not guarantee
the avoidance of these problems. Users who
operate power tools on a continual and regular
basis must monitor closely their physical
condition and the condition of this tool.
SAVE THESE INSTRUCTIONS
Check carton contents for the following:
Brushcutter attachment
Handlebar
Handlebar mounting bracket for 1" shaft
Handlebar mounting bracket for 7/8" shaft
Bracket cover (2)
Shoulder strap
Upper shoulder strap clamp
Lower shoulder strap clamp (with spacer
tabs)
• Handlebar bracket screws (4)
• Shoulder strap clamp screws (2)
• Attachment hanger
• mex wrench
_l_ WARNING:
If received assembled, re-
peat all steps to ensure your unit is properly as-
sembled and all fasteners are secure.
Examine parts for damage. Do not use dam-
aged parts.
NOTE: If you need assistance or find that parts
are missing or damaged, call 1-800-554-6723.
TOOLS REQUIRED
• Hex wrench (provided)
Before using the unit, tighten the knob se-
curely by turning clockwise.
Coupler Primary Hole
Guide Recess
Upper Locking/ Attachment
Shaft Release
Button
A
WARNING:
Make sure the locking/re-
lease button is locked h_the primary hole and
the knob is securely tightened before operat-
ing the unit. Using the wrong hole could lead to
serious injury or damage to the unit.
INSTALLING BRUSHCUTTER AT-
TACHMENT
CAUTION: When removing or installing at-
tachments, p_ace the unit on a flat surface for
stability.
1. Loosen the coupler by turning the knob
counterclockwise.
Coupler
_OOSEN
TIGHTEN Knob
2. Remove the shaft cap from the brushcut-
ter attachment (if present).
3. Position locking/release button of attach-
ment into guide recess of coupler.
4. Push the attachment into the coupler until
the locking/release button snaps into the
primary hole.
Locking/Release
Button in Primary Hole
HANDLEBAR ASSEMBLY
_& DANGER: RISKOF CUT. To avoid se-
rious injury, the barrier portion of the handle-
bar must be installed as shown on the upper
shaft of the powerhead to provide a barrier be-
tween operator and the spinning blade. Attach
handlebar mounting bracket above arrow on
safety warning decal on the upper shaft (pow-
erhead end of unit). Ensure handlebar is posi-
tioned on mounting bracket at the end of the
arrow on the handlebar decal.
NOTE: Two mounting brackets are included
with this attachment. Both brackets are provided
to adapt this attachment for use with power-
heads that have either a 1" (2.5 cm) diameter or
a 7/8" (2.2 cm) diameter upper shaft. The cor-
rect bracket must be used to ensure that the
handlebar is mounted securely to the upper
shaft before use.
4