Assembly - NordicTrack CX 1050 NEL12940 User Manual

ASSEMBLY
Assembly requires two people. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the four
included allen wrenches, assembly requires a phillips screwdriver _==_, two adjustable
wrenches_ a rubber mallet -_ andpliers_
, ,
Use the drawings below to identify the small parts used for assembly. The number in parenthesis below each
drawing is the key number of the part, from the PART LIST on pages 28 and 29. The number following the key
number is the quantity needed for assembly. Note: Some small parts may have been pre-assembled. If a part
is not in the parts bag, check to see if it has been pre-assembled.
M6 Washer M10 Split 7.6mm Spacer M8 Jam Nut M4 x 12mm M4 x 16mm
(64)-2 Washer (73)-2 (109)-2 (86)-6 Round Head Screw (98)-4
Screw (96)-1
M6 x 16mm Patch
Screw (76)-4
M8 x 44mm Button Screw (84)-8
M8 x 54mm Button Screw (83)-4 M8 x 42mm Button
Bolt (85)-4
M8 x 79mm Bolt Set (65)-2
M8 x 38mm Button Bolt
(105)-2
M10 x 108mm Button Screw (70)-2
1. Identify the Front Stabilizer (8). While another person
lifts the front of the Frame (1) and holds the Pedal
Legs (4, 5)in the position shown, attach the Front
Stabilizer to the Frame with four M8 x 44mm Button
Screws (84) and a Support Plate (104).
While another person lifts the rear of the Frame (1),
attach the Rear Stabilizer (not shown) to the Frame
in the same way.
84
•84