Nexgrill 720-0825 Manual page 16

b) Fig. 15
Using a hex key, ensure the inset screw on the
knob is loosened, but not removed. Insert Side
Burner Control Knob (M) onto the valve stem
and tighten the inset screw with a hex key (FF).
As shown in Fig. 15.
FF
M
12.
a)
b)
c)
Side Burner Installation
From underneath the side burner remove
two screws which are assembled on the
bottom of the side burner shelf (D). Open
side burner lid and place the Side Tube
Burner (U) through the opening. Place the
Side Tube Burner (U) tube over the side burner
gas valve and make sure Side Burner gas valve
is inserted into side burner tube. As shown
in Fig.16. Then with two screws secure the side
burner from underneath to the Side Burner
Shelf (D). As shown in Fig. 16.
Then with two screws secure the side burner from
underneath to the Side Burner Shelf (D). As
shown in Fig 16.
Connect the ignition wire from Firebox
Assembly (A) control panel to the side burner
igniter pin from underneath the Side Burner
Shelf & Control Panel (D)..As shown in Fig. 16.
Note: After completing side burner installation,
make sure there is no more than a 3 mm gap
between igniter pin and burner. As shown
in Fig. 17.
16
Fig. 16
Fig. 17
Side Burner
Igniter Wire
u\
A
D
Side
burner
I
/