Nexgrill 720-0825 Manual page 12

,
a)
b)
c)
d)
Bottom Panel Assembly
Loosen, but do not remove the screws that
are pre-assembled on the side of the Bottom
Panel (B).
Align the holes on the Cart Leg, Front Left (F)
and Cart Leg, Back Left (G).Place the Cart Legs
onto the screws that were loosened in the
Bottom Panel (B). As shown in Fig. 4.
Tighten the screw from outside to inside. There
are holes on the outside of the cart leg to fit the
screwdriver through. As shown in Fig. 4.
Repeat the same procedure to attach the right
cart legs to the bottom panel.
3. Triangle Bracket Assembly
Note: The flat side of the triangle should face away
from the grill.
a)
Loosen, but do not remove four screws on Bottom
Panel (B), two screws on Cart Leg, Back Left (G)
and two screws on Cart Leg (J), Back Right. Align
the holes of the Triangle brackets with the screws
in the Bottom Panel (B) and Cart Leg, Back Left (G)
and Cart Leg, Back Right (J) to connect Triangle
Bracket, Left and Right (O,P) to Cart Leg, Back
Left (G) and Cart Leg, Back Right (J). As shown
in Fig. 5
b) Tighten the screws.
Fig. 4
F
Fig. 5
G
B
,\
_\\\\\
G
\\\
\
J
P
,
a)
Front Panel Assembly
Loosen, but do not remove the screws which
are pre-assembled on the cart legs, align the
holes of the bottom front panel (S) with the screw
in the legs, then place the front panel (S) onto
the screws in the cart legs. As shown in Fig. 6.
b) Tighten the screws that were loosened in step 4a.
c)
Note: Flat facing side of the front panel (S)
should face out.
Repeat steps 4a and 4b to assemble the second
front panel (S).
Fig. 6
S
12