Craftsman WEEDWACKER Incredi-Pull 316.791700 Operator's Manual page 5

ADJUSTING THE D-HANDLE _._, Shaft Grip D-Handle REMOVING THE TRIMMER ATTACHMENT OR OTHER ATTACHMENT
1. Loosen the bolt on theD- _ j . _//
handle just enough to move _ _L_ WARNING" T° av°id seri°us pers°nal injury and damage t° the i
it (Fig. 1). unit, shut the unit off before removing or installing attachment.
2. While holding the unit in the
operating position (Fig. 12), 90° Edging Hole
move the D-handle to the (Trimmer Only}
bestl°cati°ngrip.that provides the ' _-_._'. ,_. ---.__\\ 2. X4
3. Tighten the bolt until the D- "_ Bolt \"\ > ....
handle is secure (Fig. 1). 3.
Fig. 1
OPERATING THE CONVERTIBLE
TM
COUPLER SYSTEM
_ ARNING:
Before beginning the use of any attachment, read
and understand the manual that came with the attachment. Follow
all safety information contained within.
_ ARNING:
These attachments are to be snapped into the
primary hole only. Using the wrong hole could lead to personal
injury or damage to the unit.
The Convertible
TM
coupler system enables the use of these optional
attachments. For information about attachments, call 1-800-4-MY-HOME®.
• Edger
Cultivator
Turbo Blower
Brushcutter
Pole Saw
Hedge Trimmer
INSTALLING THE TRIMMER ATTACHMENT OR OTHER ATTACHMENT
1. Turn the knob
counterclockwise to loosen
(Fig. 4).
Press and hold the release
button (Fig. 2).
While firmly holding the
upper shaft, pull the trimmer
attachment or other
attachment straight out of
the Convertible
TM
coupler
(Fig. 3).
Knob
Fig. 4
_WARNING:
Before operating this unit, be sure that the release |
|
button is fully snapped into the primary hole (Fig. 2), and that the
knob (Fig. 4) is securely tightened.
NOTE: To make installing or
removing the attachment
easier, place the unit on
the ground or on a work
bench.
1. Turn knob counterclockwise
to loosen (Fig. 4).
2. While firmly holding the
trimmer attachment or other
attachment, push it straight
into the Convertible
TM
coupler until the release
button snaps firmly into the
primary hole (Fig. 3).
NOTE: Aligning the release
button with the guide
recess will help
installation (Fig. 2).
3. Turn the knob clockwise to
tighten (Fig. 4).
NOTE: When using the line
trimmer or other
attachment to edge, lock
the attachment release
button into the 90 ° hole
(Fig. 4).
Convertible
TM
Release Button
Coupler /
Guide Recess
Fig. 2
Primary Hole
,
Upper Shaft Attachment
Shaft
Fig. 3