Fisher & Paykel E522B Installation Instructions And User Manual page 8

Installation instructions
6
Attach double sided foam to the back of the water filter head as shown
12
in Diagram 5. Write the date to be replaced on the filter (date installed +
6 months). Remove double sided foam backing and attach filter to the
desired position as located in step 11 (refer to previous page).
Run the ¼" (6 mm) tubing to back of the fridge ensuring there is enough
13
tubing to pull out the refrigerator for service.
Connect tubing into the water (solenoid) valve located on the right hand
14
side of the unit (compressor) compartment as shown in Diagram 7. Beware
of hot pipes.
Pull gently on tubing to ensure it is locked in as shown in Diagram 8.
15
Replace compressor cover if present.
The completed installation should look like Diagram 9 on page 7.
16
Turn isolating faucet on and check that all connections are dry and free of drips.
17
Coil water line tubing behind the fridge. Push your refrigerator into place being careful not to
18
kink or squash the water line running into the water (solenoid) valve.
Turn on refrigerator.
19
The first time you require water out of the dispenser, there will be a delay while the water
20
reservoir fills up. As this is happening, the
symbol will stop flashing.
Run a further 3 qt (3 liters) through the system to ensure the reservoir is flushed out.
21
You are now ready to enjoy chilled water and ice dispensing from your Active Smart™ refrigerator.
22
Diagram 7
Diagram 6
Diagram 8
Fig.7 Waterline connection
to refrigerator
symbol will flash. Once the reservoir is full, this
Diagram 5
Fig.6 Double sided
foam attachment