Magic Chef RS-1 User Manual page 8

S rPame
To prevent the cooktop from discolor-
ing or staining:
• Clean cooktop after each use.
• Wipe acidic or sugary spills as soon
as the cooktop has cooled as these
spills may discolor the porcelain.
Saafa:f BurrB
The sealed burners of your range are se-
cured to the cooktop and are not designed to
be removed. Since the burners are sealed
hlto the cooktop, boilovers or spills will not
seep underneath the cooktop. However, the
burners should be cleaned after each use.
(See page 15 for cleanhlg directions.)
Unlike a range with stan-
dard gas burners, this
cooktop does not lift-up
nor is it removable. Do not
attempt to lift the cooktop
for any reason.
speed
(select models)
Select ranges feature one high speed burner
located in the right front position. This
burner offers higher speed cooking that
can be used to quickly bring water to a boil
and for large-quantity cooking.
Si BLrner
(select models)
Select models feature a low turn down
simmer burner located at the left rear
position. Use this burner to keep foods
warm, melt chocolate or gently simmer
sauces, soups or stews.
Burrmr Grdk
The grates must be properly positioned
before cooking. Improper installation of
the grates may result in chipping of the
cooktop.
Do not operate the burn-
ers without a pan on the
grate. The grate's porce-
lain finish may chip with-
out a pan to absorb the
heat from the burner
flame.
Although the burner grates
are durable, they will
gradually lose their shine and/or dis-
color, due to the high temperatures of the
gas flame.
Drip Pals -
Removeable porcelain covered drip pans
are available for use with this appliance
to help contain spills. Call 1-800-688-8408
to order.
C rliA rlicrmf Burrmm
Freestanding ranges with conventional
gas burners feature a lift-up cooktop.
To raise the cooktop: when
cool, grasp
the front I
edge of the
cook-top i
i
and gently i
lift up until i
the two sup- i
port rods, if equipped, at the front of the
cooktop snap into place.
To lower: Hold the front edge of the
cooktop and carefully push back on each
support rod, if equipped, to release the
notched support. Then gently lower the
top into place. The support rods will slide
into the cooktop frame.