Table of Contents
Advertisement
7
Turning on Your VCR
"IV and VCR
CHANNEL
3/4 Switch,
I
÷.
Set the TV to channel
3 or 4, whichever
channel the CH3/CH4
switch on the back of
the TV is set to.
:7
Press the POWER
button.
</-.
Press the Number 1
button for English or
the Number 2 button
for Spanish on-screen
displays.
Remote Control
Press the CHANNEL
(Up) button.
Press the MENU
button.
. If you do not_ee an)" on-screen displays when you turn on the VCR, repeat
the steps under "Hooking Up Your VCR" on page six, then try again. If
you still ,,do_ not see any on-screen displays, follow the steps under "'Channel
Memory ' on page 26 and "'Language Selection" on page 28.
[ • 7b skip this feature and play a tape immediately, insert a tape with its
record tab removed. Playback wi!l start immediately. Or, to skip step 3,
press the MENU button. All on-screen displays will be in English. To skip
slrep 4, press the STOP button. Channels will nor be programmed, and
TUNER NOT SET will appear on-screen.
• Z'ochange the language or program channels at a later time, follow the
si'eps on pages 26 and 28.
• If you tO" to program charnels when there is no antenna or cable connected
to the VCR, programming
will appear to take place, but eventually NO TV
SIGNALS will appear on-screen- If this happens, connect an antenna or
cable to the VCR and try again.
• You cannot program channels if a cable converter box is connected to a
VCR that is connected to a TV lf you have this kind of connection, see
page 38for details.
Q
o
o
:
:
:
Before turning on your VCR, make sure
. there are batteries in the remote conn-ol and
the VCR and TV are connected (see pages
five and six).
Turn the TV on. Set it to the same channel
as the CH3/CH4 switch on the back of the
VCR.
.-7-
Press the VCR burton, then the POWER
button. The VCR light will appear on the
display panel of the VCR and the language
select display shown below will appear.
Press the Number 1 button to select EngJish
on-screen displays or the Number 2 button
to select Spanish on-screen displays.
Press the MENU button. The channel pro-
gram display shown below will appear.
Press the CHANNEL (Up) button to be_n
automatic channel programming. The VCR
will place all of the channels you receive
into its memory, so when you scan through
channels using the CHANNEL (Up/Down)
buttons, you'll only scan through channels
tha_ you receive. When channels are pro-
grammed, AUTO SET COMPLETED will
appear on-screen briefly. Then the TV will
go to the lowest channel programmed.
Advertisement
Table of Contents
