Before Requesting Service - Magnavox VRT364 Owner's Manual

42
Before Requesting Service
If you are having problems with your VCtL check the following list of problems and possible solutions before requesting ser-
vice. You may be abte to solve the probtem yourself.
Power
No power
Power failure
Recording/Playback
TV program cannot be recorded
VCR wiI1 not _rform a timer
recording
There is no playback picture, or
the playback picture is noisy or
contains streaks
During special effects playback,
the picture is noisy or contains
vealSealjitter when using a TV
with an automatic vertical hold
conttol
The top of the playback pictures
waves back and forth excessively
Remote Control
VCR cannot be controlled with
remote control
Number buttons won't work for
channels above 69
(continued on page 43)
o
o
e
o
o
• Make sure the power plug is completely corm_xed to an AC (akemafing current) outlet.
• Make sure the power is turned on.
• Follow the steps on page seven to select a language and pro=_'am channels, if
prompted to do so. Then follow the steps on page 10 to reset the clock.
• Check the connections between the VCR, TV, and the antenna/cable (page six).
• Make sure the band selected (VHF/Uq-IF)matches your antenna/cable system.
• Make sure the tape has a record tab (page five).
• Make sure the recording start and stop times are set correctly (pages 20 - 25).
• Make sure the VCR power is off.
• ,Make sure the clock is set (page 10).
• The VCR may not perform or continue a timer recording if a power interruption
of more than one minute occurs daring the timer recording, even if the power
comes back on afterward.
• Make sure the TV is on the same channel as the VCR's CH3/CH4 switch (page six)
• Make sure the VCR is in VCR position (pages I3 and 15).
• Make sure channel 3 or 4 is properly adjusted.
• Adjust the tracking (page 32).
Set the TV's vertical hold control to manual, then adjust.
• Because the VCR playback si,_d is not a_ stable as an off-the-air TV simaa!, the
top of the "IV screen may waver during playback. To stop this, slowly ram the
horizontal hold control on the TV. If the TV does not have a horizontal ho!d con-
tml, or if adjusting the control does not help, contact your TV service center.
• Press VCR button on the remote control, then try again.
• Aim the remote control directly at the VCR's remote sensor (page five).
• Remove all obstacles between the remote control and the VCR (page five).
• Inspect and!or replace the batteries in the remote control (page five).
• Select CABLE TV from the tuner setup menu, then auto program channels
(page 26).
j Periods'c maintenance is required to maintain your VCR's continued excellent performance. Your VCR has an automatic head i
sette. However, this feature is preventative only. If the video heads are vet3"clogged, take your VCR to an authorized service center, r
!