Table of Contents
Advertisement
18
One Touch Recording
The one touch recording (OTR) function
allows you to proem-aman immediate timed
recording 30 minutes to four hours long
without setting the timer. Before you
begin, make sure:
g Channels have been programmed.
'" The desired recording speed (SP, LP,
SIP) has been selected with the (Tape)
SPEED button.
There is a tape in the VCR (make sure
the tape's record tab is intact and the tape
is long enough to record the pro m'am(s).
_: The VCR is in VCR position.
Starting an OTR
..<
Use the CHANNEL (Up/Down) buttons or
Number buttons to select the channel you
want to record.
Press the REC(ord)/OTR button twice. The
screen below will appear.
1
i
\
;
Press the REC(_rd)/OTR button until the
desired recording length (30 minutes to four
hours) is in the upper left corner of the
screen. Recording will be_n immediately.
Stopping an OTR
To stop an OTR before recording is f'm-
ished, press the STOP button or the
POWER button. To cancel the OTR but
continue recording, press the REC(ord)/
OTR button repeatedly until REC appears
OP.-scr_.,"L
Remote Control
o
o
t
Q
o
Press the
REC(ord)/OTR
button three to ten
times to start an
OTR and select a
recording
length.
(-c_m_--cy:3
E]®
@@
O c:::_
O
Use the CHAN.rNEL
(Up/Down)
button or
Number buttons to
select the channel
you want to record.
• To check the time remaining
for
an
OTR after the OTR has been set, press
the STATUS burton.
• To change the recording length while an OTR is in progress, press the
REC(ord)/OTR button until the desired length is displayed on-screen.
• If you begin an OTR when a recording is paused, the OTR will begin.
[
I
You can not pause the recording (for example, during commercials), during I
an OTR mode.
]
I
Advertisement
Table of Contents
