GE Profile 23 Owner's Manual And Installation page 28

Installation Instructions
INSTALLING THE REFRIGERATOR
(CONT.)
[] PUT THE REFRIGERATOR IN PLACE
Move the refrigerator to its final location.
rsi LEVEL THE REFRIGERATOR
The refrigerator can be leveled by adjusting
the rollers located near the bottom hinges.
_T_2-- TL 2-_ 2--/2 -J
Raise
Rollers have three purposes:
• Rollers adjust so the door closes easily when
opened about halfway. (Raise the front about
5/8" [16 mm] from the floor.)
• Rollers adjust so the refrigerator is firml U
positioned on the floor and does not wobble.
• Rollers allow you to move the refrigerator
away from the wall for cleaning.
To adjust the rollers on 23' 133" wide}, 25'
and 26' models:
• Turn the roller /
adjusting screws
J
clockwise to raise
the refrigerator,
counterclockwise
to lower it. Use
a 3/8" hex socket
or wrench, or
I--I
an adjustable
wrench.
Roller adjusting screw
gl
LEVEL THE REFRIGERATOR
(cont.}
To adjust the rollers on 23'125' CustomStyle'"
models:
Turn the front roller
adjusting screws
clockwise to raise
the refrigerator,
counterclockwise
to lower it. Use a
3/8" hex wrench
with extension, or
an adjustable wrench.
Roller adjusting screws
These models also have rear adjustable rollers
so you can align the refrigerator with uour
kitchen cabinets. Use a 3/8" hex wrench with
extension to turn the screws for the rear rollers-
clockwise to raise the refrigerator,
counterclockwise to lower it.
[] LEVEL THE DOORS
Adjust the refrigerator door to make the doors
even at the top.
To align:
Using a 7/16" wrench, turn the door adjusting
screw to the right to raise the door, to the left
to lower it.
NOTE:
A nylon plug, imbedded in the threads
of the pin, prevents the pin from turning unless
a wrench is used.
After one or two turns of the wrench, open
and close the refrigerator door and check
the alignment at the top of the doors.
Doors should be even at top
I
28