Troubleshooting - Fisher & Paykel DW60 Installation Instructions And User Manual

Problem
Dishwasher will not start.
Lower spray arm rotates with
difficulty.
Lid of detergent dispenser
cannot be closed.
Remnants of detergent stuck
inside dispenser.
Indicator lights do not
extinguish after washing has
finished.
Water remains inside
dishwasher after wash has
ended.
Foaming.
Stops suddenly during wash. Power supply has been interrupted. Check power supply.
Probable cause
Power supply is not connected.
The door is not properly closed.
Programme button has not been
pressed.
Water tap not turned on.
Blocked strainer in water intake
hose.
Spray arm is blocked by small items
or food remains.
Detergent compartment has been
overfilled.
Detergent dispenser is clogged
with remnants of detergent.
Compartment was damp when
filled with detergent.
Power button is ON.
Drain hose is crimped, bent or
blocked.
Pump is jammed.
Filter/s blocked.
The wash is still running.
Incorrect amount/type of detergent
used.
Too much egg in the wash load.
Rinse aid setting too high.
Rinse aid spills not wiped up.
Water supply has been interrupted. Check water supply.

Troubleshooting

What to do
Connect the power supply.
Close the door.
Select a programme.
Ensure the water is connected
and turned on.
Check strainer – located in
the inlet supply hose where it
screws into the tap.
Clean spray arm.
Remove detergent until the lid
can be closed.
Wipe dispenser out with a
damp cloth. Dry before adding
detergent.
Wipe dispenser out with a
damp cloth. Dry before adding
detergent.
Turn the Power button off.
Check hose and straighten if
needed.
Call your Fisher & Paykel
Authorised Service Centre.
Clean the filter/s.
Wait for the programme to end.
See the 'Detergent' section
or consult the detergent
manufacturer's instructions.
Increase the amount of
detergent.
Decrease the rinse aid setting.
Ensure that all rinse aid spills are
wiped up when they occur.
23