Philips SBC SC 364 Instructions For Use Manual page 6

4. OPERATION
IMPORTANT!
Before using the Baby phone, check the sound
transmission. This checks whether a unit is
broken, or whether units are placed out of
range of each other. After this first check,
sound transmission should be checked on a
regular basis as follows:
Have an adult softly speak into the 'baby unit'.
Sounds transmitted from the baby room
should be heard clearly via the 'parent unit' in
another room.
CHANNEL SELECTION
– The Baby phone can use 2 different
channels for radio signal transmission. If
sound reception is very poor, or other radio
signals are being picked up, please try the
other transmission channel as follows:
• Move the channel selector on both units to
the other channel (fig. 1.1 and fig. 1.4) .
Note: Always make sure the channel switches
on both units are set to the same position.
This ensures optimum reception.
VISUAL SOUND INDICATION
The 'parent unit' has a sound level indicator,
which visually alerts parents to their baby's
crying, but no sound is heard via the speaker.
To operate the sound level indicator:
• Make sure the 'baby unit' is operational in
VOICE mode.
• Switch the 'parent unit' to ON to the
minimum sound level by adjusting the
volume control (fig.1.2) .
– The red POWER LED lights up.
– If a sound signal is received from the 'baby
unit', the green sound LEVEL LEDs (fig. 1.3)
light up. The louder the sound, the more
LEDs light up.
6
SBC364page 6
RECHARGEABILITY
The 'parent unit' has a recharging function. If
the rechargeable batteries are empty they can
be recharged easily via the recharging base. To
recharge batteries:
• Make sure that the mains power adapter is
correctly connected to the recharging base.
– If the mains power adapter is connected
correctly, the red CHARGE LED on the
recharging base lights up.
• Place the 'parent unit' inside the recharging
base; batteries start to recharge.
– Totally empty batteries will take up 12-14
hours to fully recharge.
BELT-CLIP
With completely charged batteries, the
'parent unit' can be used as a truly cordless
product. The unit can be carried in and around
the house, using the easy belt-clip. This clip
can easily be attached to and removed from
the 'parent unit' (fig. 5) .