Important Safety Instructions - Philips MT3120 User Manual

1 Important safety
instructions
Power requirements
The voltage on the network is classified as TNV-
3 (Telecommunication Network Voltages), as
defined in the standard EN 60950.
Warning
•
The electrical network is classified as hazardous. The
only way to power down the charger is to unplug the
power supply from the electrical outlet. Ensure that the
electrical outlet is always easily accessible.
To avoid damage or malfunction
Caution
•
Use only the power supply listed in the user
instructions.
•
Risk of explosion if battery is replaced by an incorrect
type.
•
The battery is not designed to be replaced.
•
Dispose of used batteries according to the instructions.
•
Do not open the phone as you could be exposed to
high voltages.
•
Do not let small metal objects come into contact with
the product. This can deteriorate audio quality and
damage the product.
•
Metallic objects may be retained if placed near or on
the handset receiver.
•
Do not use the product in places where there are
explosive hazards.
•
For pluggable equipment, the socket-outlet shall
be installed near the equipment and shall be easily
accessible.
•
This is a handsfree product with high speaker volume.
Make sure the product is not too close to your ear.
•
This equipment is not designed to make emergency
calls when the power fails. An alternative has to be
made available to allow emergency calls.
•
Do not allow the product to come into contact with
liquids.
•
Do not expose the phone to excessive heat caused by
heating equipment or direct sunlight.
•
Do not use any cleaning agents containing alcohol,
ammonia, benzene, or abrasives as these may harm
the set.
•
Do not drop your phone or allow objects to fall on
your phone.
•
Do not let children play with the lanyard.
•
Use the clip and lanyard together to avoid dropping the
phone to the floor.
•
Active mobile phones in the vicinity may cause
interference.
•
The full functionality of the phone can only be
guaranteed when it is registered with a GAP
compatible base station.
About operating and storage temperatures
• Operate in a place where temperature is
always between 0°C to +40°C (up to 90%
relative humidity).
• Store in a place where temperature is
always between -20°C and +45°C (up to
95% relative humidity).
• Battery life may be shorter in low
temperature conditions.
EN 3