GE DBL333 Owner's Manual And Installation Instructions page 15

Mobile Home Installation
[]Dryer
MUSTbe exhausted
outside (outdoors, not
beneath tile mobile home) using metal ducting
that will not support combustion. Metal ducting
must be 4" (10.16 cm) in diameter with no
obstructions. Rigid metal duct is preferred.
[]If dryer is exhausted tbrough tim floor, the
exhaust system MUST NOTterminate beneatb the
mobile home. Termination MUSTbe securely
fastened to tbe mobile home structure.
]When installing a dryer into a mobile home,
a provision must be made for outside make-up
ai_: Provide an opening with a flee area of at
least 25 square inches for introduction of outside
air into tim dryer room.
[]Gas drym.'s MUSTbe fastened to the floor
using Mobile Home Installation Kit
Pub. No. 14-D346-33.
[]See tbe Exhaust System Requirements section
1or other important venting information.
[] Installation MUSTcontorm to current
Manulactured Home Construction & Safety
Standard (which is a Federal Regldation Title
24 CFP,--Part 32-80) or, when such standard is
not applicable, with American National Standard
1or Mobile Homes, ANSI/NFPA No. 501B.
Correct
Incorrect
Thedryer is designedunder ANSI Z 21.5. I
for HOMEUSEonl_
Rough-&Dimensions
!
267/8" --
-- (68.3cm)
[3--" Electdcal connection
43 5/8"
(110.7era}
,, I
n-
"_ 3/8,,(0 96era)Dia/
gas pipe
35 *_
{915 cm}
1
L
f
1" (254 cm}
47 1/2"
Dooropen
90
4 3/8"
(111 crn}'_.
OptionaP~-,-_,, '
vent knockout '.. -
_1_
27"
/
3 3/4" (686 cm) 3 3/4"
{9.5cm} {9.5cm}
REARVIEW SIDEVIEW
Servicing - Consideration must be given to provide adequate clearances for installation and servicing.
15