Advertisement
STEP 3:
TRIM
INSTALLATION
Your built-in oven is packed with a shipping base pad
on the bottom of the unit. To protect the lower front tdm
from damage, do not remove unit from base pad until
ready to Install In cabinet.
The oven door must be
removed before you are ready to Install the oven. Make
electdcai connections
and then follow steps 3A, 3B,
and 3C.
Make
sure you do not Up the unit forward
dudng
installaUon
or you may bend the lower
trim.
3A:
Remove
the oven door.
Open the door to the stop position (See Fig. 4A).
•
Grasp the dour at each side and lift up and off the
hinges (See Fig. 4B).
CAUTION:
When
the
door
is removed
and
hinge
arms
are at stop position,
do not
bump
or try to move
the
hinge
arms.
The
hinges
could
snap back causing
an injury to the
hands or damage
to the porcelain
on the front
of the range.
Cover
the hinges with toweling
or empty
towel
rolls
while
working
in the
oven area.
STOP POSITION
HINGE
Fig. 4B
Your built-in oven is pocked
with • shipping base
pad on the bottom
of the unit.
The lower front tdm
is shipped separately and should not be USed until you
are ready to install the oven with the door removed.
1. Remove
the oven door us shown
in step 3A of
the installation
instructions
packed
with your
oven,
2. After door is removed, attaCh lower tdm to front
frame with three Phillips head screws provided, and
to side tdm with two #20 torx head screws provided.
(See FI0. S).
3. Nextm follow steps 3B end 3C on page 7 of your
installation
Instructions
to secure
the oven to
the oabinet
cutout and rer3ace
the oven door.
j,*
qr
FIg. S
A
CAUTION:
The bottom
trim provides
am open-
ing for cooling
air to enter
the
cabinet,
This
opening
should
never he blocked.
CAUTION:
Do not lift oven or oven door by
handle.
Door glass
breakage
or
handle
damage
may occur.
CAUTION:
The outer
door glass extends
be-
yond the door frame on each side;
be careful
not to impact
this ex-
posed
9lass.
6
Advertisement
