Step 2, Door Trim Removal For Above 36" Installation Only; Step 3, Slide The Oven Into The Cutout - GE Advantium PWB7030 Installation Instructions Manual

120v built-in speedcook and 120v built-in convection ovens
Hide thumbs Also See for Advantium PWB7030:
Table of Contents

Advertisement

Available languages

Available languages

2 DOOR TRIM REMOVAL FOR
ABOVE 36 INSTALLATION
ONLY
If installing the Advantium/Convection 120V
Oven above 36 from the floor, you may remove
the plastic trim from the bottom of the door for
esthetic purposes if desired.
CAUTION
If installing the Advantium/
Convection 120V Oven below 36 , do not
remove the plastic door trim due to burn risk
to children. The plastic trim acts as insulation
and will help prevent burns to children from hot
surfaces.
• If installing above 36 , remove the 3 screws
that secure the plastic trim to the bottom of the
door.
• Discard plastic trim. Replace screws.
Installation Instructions
3 SLIDE THE OVEN INTO THE
CUTOUT
CAUTION
the oven into the opening. Grasp the bottom at
front and rear. DO NOT USE THE HANDLE TO
LIFT THE OVEN. DAMAGE WILL OCCUR.
• Lift and hold the oven at the front of the opening.
Hold the oven at an angle and plug in the power
cord.
• Carefully, slide the oven into the cabinet part
way. Leave the oven a few inches forward of
the cabinet frame.
• Check to be sure the power cord is not trapped
under the oven or along the sides of the oven.
13
Two people are required to lift

Advertisement

Chapters

Table of Contents
loading

Table of Contents