Central Pneumatic 67708 Set Up And Operating Instructions Manual page 5

5. do not leave compressor unattended
for an extended period while plugged
in. unplug compressor after working.
6. keep compressor well-ventilated. do
not cover compressor during use.
7. Drain Tank daily and after use. Internal
rust causes tank failure and explosion.
8. Add correct amount of compressor
oil before first use and every use.
Operating with low or no oil causes
permanent damage and voids warranty.
9. Do not remove the valve cover or adjust
internal components.
10. Compressor head gets hot during
operation. Do not touch it or allow
children nearby during or immediately
following operation.
11. Do not use the air hose to move the
compressor.
12. Release the pressure in the storage tank
before moving.
13. The use of accessories or attachments
not recommended by the manufacturer
may result in a risk of injury to persons.
14. All air line components, including hoses,
pipe, connectors, filters, etc., must be
rated for a minimum working pressure
of 150 PSI, or 150% of the maximum
system pressure, whichever is greater.
SKU 67708 For technical questions, please call 1-800-444-3353.
15. USE OF AN EXTENSION CORD IS NOT
RECOMMENDED. If you choose to
use an extension cord, use the following
guidelines:
recommended mInImum WIre
GauGe For eXtenSIon cordS
(120 Volt)
namePlate
amPereS
(at full load)
0 – 6
6.1 – 10
10.1 – 12
12.1 – 16
table a
a. Make sure your extension cord is in
good condition.
b. Be sure to use an extension cord
which is heavy enough to carry the
current your product will draw. An
undersized cord will cause a drop in line
voltage resulting in loss of power and
overheating. Table A shows the correct
size to use depending on cord length
and nameplate ampere rating. If in
doubt, use the next heavier gauge. The
smaller the gauge number, the heavier
the cord.
16. Industrial applications must follow OSHA
guidelines.
17. Maintain labels and nameplates on the
compressor. These carry important
safety information. If unreadable or
missing, contact Harbor Freight Tools for
a replacement.
18. This product is not a toy. Keep it out of
reach of children.
19. Operate unit on level surface. Check
oil level daily and fill to marked level if
needed.
eXtenSIon cord
lenGtH
25' 50' 100'
18 16 16
18 16 do not use.
16 16 do not use.
14 12 do not use.
Page 5
150'
14