GE P2B930 Owner's Manual And Installation Instructions page 43

Installation Instructions
Read these instructions completely and carefully.
[Z] Gas Supply Requirements
Recommended Gas Pipe Outlet Locations
NOTE: Make gas connections on
the left side of the cutout opening.
30"
Recommendedare j :l
for through-the-wall " ' I
connection of pipe
stub/shut-off valve.
J This area allows flush i
installation to rear
wall.
Recommended area for
through-the-floor connection
of pipe stub/shut-off valve.
_To prevent
drafts from affecting burner
operation, seal all openings in floor
and wall.
Provide Adequate Gas Supply
Your range is designed to operate at a pressure orS" of water column on natural gas or,
if designed for LP gas (propane or butane), 10" of water column.
Make sure you are supplying your range with the
type of gas for which it is designed.
This range is convertible for use on natural or
propane gas. If you decide to use this range on LP
gas, conversion must be made by a qualified LP
installer before attempting to operate the range on
that gas.
For proper operation, the pressure of natural gas
supplied to the regulator must be between 5" and
13" of water column.
For LPgas, the pressure supplied must be between
10" and 13" of water column.
When checking for proper operation of the regulator,
the inlet pressure must be at least 1" greater than
the operating (manifold) pressure as given above.
The pressure regulator located at the inlet of the
range manifold must remain in the supply line
regardless of whether natural or LPgas is being
used.
A flexible metal appliance connector used to connect
the range to the gas supply line should have an I.D.
of 1/2" and be 5 feet in length for ease of installation.
In Canada, flexible connectors must be single wall
metal connectors no longer than 6 feet in length.
43