GE DCVH515 Owner's Manual page 3

ge.com
%
PROPER INSTALLAtiON
This dryer must be properly installed and located in accordance with the Installation Instructions
before it is used. If you did not receive an Installation Instructions sheet, you can receive one by
visiting ge.com, or by calling 8##.GE.CARE$ (800.432.2737).
[] Properl} gromld dr) er to confiwm _itll all
governing codes and ordinances. Fol]o_ details
in Installation Instructions.
[] Instnll or store where it will not be exposed to
temperatures below fl'eezing or exposed to
tile _ eathe_;
[] Connect to a properly rated, protected and sized
power supply circuit to m_)id electdcal ovedoad.
[] Remove tile colored protective film fi'om both
tile control panel and ,lie doo_:
[] Remo\v all shaq) packing items and dispose
ot all shil/ping matedals propedy.
[] DO
IIot reIllove tile vent protector ti'oln tile
back of tile chyel:
[] Pull tile pxotector out and down to its lowest
position and connect ,lie exhaust duct to tile
drvel; Tile loweied protector will prevent tile
duct ii'om getting crushed.
Exhaust/Ducting:
[7] Dryers MUSTbe exhausted to tile outside to
prevent l'u'oe, _ _m/ounts of moisture and lint
ti'om being blown into tile room.
[_Lse onl) ngld metal or flexable metal 4
diameter duct_ork inside tile dr\er cabinet or
ior exha usting to tile outside. USE OF PLASTIC
OR OTHER COMBUSTIBLE BUCTWORK CAN
CAUSEA FIRE.PUNCTURED BUCTWORK CAN
CAUSEA FIREIF IT COLLAPSESOR BECOMES
OTHERWISERESTRICTED IN USE OR DURING
iNSTALLATION.
For complete details, fbllow tile Installation
h_structions.
3