Preparing To Install The Refrigerator; Water Supply To The Icemaker; Refrigerator Location; Clearances - GE TFX24 Owner's Manual

Preparing to install the refrigerator.
Read _eSe instmctio, s !comp!ete_ and Carefully.
m
WaterSupplyto the Icemaker
You will need to connect the icemaker to a cold water line.
A water supply kit (containing copper tubing, shutoffvalve, fittings
and instructions) is available at extra cost from your dealer.
Refrigerator L ocation
Do not install the refrigerator where the temperature will go below
60°F. (16°C.) because it will not run often enough to maintain
proper temperatures.
Install it on a floor strong enough to support it fully loaded.
Clearances
Allow the following clearances for ease of installation, proper air
circulation and plumbing and electrical connections:
Sides 5/8" (15 mm)
Top l" (25 mm)
If built-in, allow 7/8"[22 ram] for hinge covers,
Back 1" (25 ram)
If the refrigerator is against a wall on either side, allow the following
door clearances:
For 24' models:
Refreshment center side
Freezer side
For 27' models:
Refreshment center side
Freezer side
2%" (67 mm)
3/4" (19 mm)
3V(' (89 mm)
]V(' (38 mm)
28