Installation Instructions; Preparing To Install The Refrigerator - GE M2S9FPMKII Owner's Manual & Installation Instructions

Installation Instructions

If you have questions, call 1.800.561.3344 or visit our Website at: GEAppliances.ca.
BEFORE YOU BEGIN
Read these instructions completely and
carefully.
IMPORTANT –
•
local inspector's use.
IMPORTANT –
•
and ordinances.
Note to Installer –
•
instructions with the Consumer.
Note to Consumer –
•
for future reference.
• Skill level – Installation of this appliance requires
basic mechanical skills.
• Completion time – Refrigerator Installation
• Proper installation is the responsibility of the
installer.
• Product failure due to improper installation is not
covered under the Warranty.
REFRIGERATOR LOCATION
• Do not install the refrigerator where the
temperature will go below 55°F (12.7°C) because
it will not run often enough to maintain proper
temperatures.
• Do not install the refrigerator where the
temperature will go above 100°F (37°C) because
it will not perform properly.
• Do not install the refrigerator in a location exposed
to water (rain, etc.) or direct sunlight.
• Install it on a floor strong enough to support it fully
loaded.
29-6283
Save these instructions for
Observe all governing codes
Be sure to leave these
Keep these instructions
15 minutes
Reversing the Door Swing
15 minutes
CLEARANCES
Allow the following clearances for ease of
installation, proper air circulation and plumbing and
electrical connections.
Sides 1/8" (3 mm)
Top 1/8" (3 mm)
Back 1"(25mm)
ROLLERS AND LEVELING LEGS
Leveling legs near each front corner of the
refrigerator are adjustable. They firmly position the
refrigerator and prevent it from moving when the
doors are opened. Leveling legs should be set so
the front of the refrigerator is raised just enough that
the doors close easily when opened about halfway.
Turn the leveling legs clockwise to raise the
refrigerator, counterclockwise to lower it.
Leveling Leg
Low
High
9