Preparing To Install The Refrigerator - GE TFM20JRB AA Owner's Manual

Preparing to install the refrigerator.

Read these instructions completely and carefully.
Water Supply to the Icemaker
If the refrigerator has an icemaker, it will have to
be connected to a cold water line.
Refrigerator Location
Do not install the refrigerator where the
temperature will go below 60°F (16°C)
because it will not run often enough to
maintain proper temperatures.
Clearances
Allow the following clearances for ease of
installation, proper air circulation, plumbing
and electrical connections:
20', 22', 25' and 27' Models
Sides 5/8" (15 mm)
Top 1" (25 mm)
Back 1" (25 mm)
If built-in, allow 7/8" (22 mm) for hinge covers.
24' Model
Sides 1/8" (3 mm) 1/8" (3 mm) 1/8" (3 mm)
Top 1" (25 mm)
Back 1/2" (13 mm) 1/2" (13 mm) 1/2" (13 mm)
If built-in, allow 7/8" (22 mm) for hinge covers.
20
(on some models)
28' Model 30' Model
1/8" (3 mm) 1/8" (3 mm)
A water supply kit (containing copper tubing,
shutoff valve, fittings and instructions) is
available at extra cost from your dealer.
Install it on a floor strong enough to support it
fully loaded.
If the refrigerator is against a wall on either side,
allow the following door clearances on each side
for a 90° door opening:
20', 22', 24', 25', 28' and 30' models
3/4" (19 mm)
27' models
1 1/2" (38 mm)
90°