GE Profile Performance WPSE7003 Owner's Manual page 8

About controls features.
START/PAUSE
• After you have selected a new cycle, press once to start the cycle.
• Press twice to select the last cycle used and start the washer.
• If the washer is running, press once to interrupt the cycle; press again to continue
the cycle.
STOP/CANCEL
This pad should notbe used to interrupt or pause a cycle.
Pressing this pad will cancel the current settings and the settings will be lost.
E$'_ TIME REMAINING
Estimated )'tme Remaining
• Displays the approximate time remaining until the end of the cycle.
• If the estimated time remaining is more than 60 minutes, "1H" will flash in the
display, followed by the additional remaining minutes, When the time remaining is
less than 60 minutes, the timer will count down.
• Cycle time is affected by how long it takes the washer to fill. This depends on the
water pressure in your home. The "smart" timer "learns" the amount of time it
takes to fill your washer and adjusts the total time accordingly.
NOTE:If PRESOAKisselected
and a follow up wash cycle is not chosen, two dashes
will come up in the display.
SpatSpray
When you open the washer lid and press the SPOTSPRAYbutton, you will see a short stream
of cold water,
[_] Open the washer lid.
[] Press the SPOT SPRAYbutton.
(You will see a short stream of water,)
[_] Dampen your soiled garment with the SPOT SPRAYoption and rub your favorite
pretreatment product into soiled area.
NOTE.'The SPOT SPRAYoption will not work if
• the washer lid is down
• the washer tub is filling
• the water has already reached the level you selected
8