GE Profile Performance WPSE7003 Owner's Manual page 14

Before you call for service...
PossibleCauses What ToDo
Result of normal were on • While this is not caused by the washer, you can slow the
poly-cottOnfuzzy fabricsMends and pilling process by washing garments inside out.
Pins, snaps, hooks, sharp • Fasten snaps, hooks, buttons, and zippers.
OrSX_ wear buttons, belt buckles,
zippers, and sharp objects • Remove loose items like pins, objects in pockets
left in pockets and sharp buttons.
• Turn knits (which snag easily) inside out.
Undiluted chlorine bleach • Check bleach package instructions for proper amount.
• Never add undiluted bleach to wash or allow clothes
to come in contact with undiluted bleach.
Chemicals like hah- bleach • Rinse items that may have chemicals on them before
or dye, permanent wave washing.
solution
Improl_r soiling • Avoid mixing heavy items (like work clothes) with
light items (like blouses).
• Try a fabric softener.
Overloading or • Load your washer so clothes have enough room
incorrect water level to move freely.
Incorrect wash and • Match Cycle selection to the type of fabric you are
dry cycles washing (especially for easy care loads).
Repeated washingin • Wash in warm or cold water.
water that is too hot
Possible Causes What ToDo
i_MmrlMcmes _le.Ij The HAND WASHeycle was chosen • This is nonnal. The HAND WASH cycle has a short soak
period.
_ tCt_'t 010_ID Washer is tmplugged • Make sure cord is plugged securely into a working oudet.
Water supply is turned off • Turn both hot and cold faucets fully on.
Controls m'e not set proporly • Check controls.
Lidis open " Close lid.
Carcmt breaker/fusels • Cheek house circuit breakers/fuses. Replace fuses or
tripped/blown reset breaker. Washer should have separate outlet.
Electronics need to be reset • Unplug washer, wait 2 minutes, plug back in, and press
START.
START was not pressed • Press START.
Extremely low water pressure • Press START agam.
/4