Summary of Contents for Firstech DATA CONTROLLER FT-MB164-DC
Page 1
Data Controller (DC) Remote Start for Mercedes 2006 - 2009 ML, GL, and R Class Welcome to the installation guide for the 2006 to 2009 ML, GL, and R Class Mercedes Benz. Please thoroughly review this manual before installation as there are details that are essential to operation of the vehicle.
Page 2
Data Controller (DC) Remote Start for Mercedes 2006 - 2009 ML, GL, and R Class Instructions 1. Remove the HVAC panel by pulling outward to release the lower clips. (pic 1) 2. Pull down on the panel to release the upper clips. (pic 2) 3.
Page 3
Data Controller (DC) Remote Start for Mercedes 2006 - 2009 ML, GL, and R Class 27. Reinstall the COMAND by first plugging in all harnesses and antenna connections that you removed in step 7. 28. Slide the COMAND back into its opening. 29.
Page 4
Data Controller (DC) Remote Start for Mercedes 2006 - 2009 ML, GL, and R Class 5) Pull down on retaining bars 7) Access EIS wiring through opening External view of EIS module 9) Plug the harness into the rear of the EIS FT-MB164-DC Installation Guide 6) Remove and disconnect COMAND unit 8) Make sure the valet switch is off...
Page 5
Data Controller (DC) Remote Start for Mercedes 2006 - 2009 ML, GL, and R Class Firstech, LLC. is not responsible for any damages whatsoever, including but not limited to any consequential damages, incidental damages, damages for loss of time, loss of earnings, commercial loss, loss of economic opportunity and the like that may or may not have resulted from the installation or operation of the Data Controller for Mercedes.
Need help?
Do you have a question about the DATA CONTROLLER FT-MB164-DC and is the answer not in the manual?
Questions and answers