GE Appliances JGB850 Owner's Manual And Installation Instructions page 41

Installation Instructions
LOCATION
Do not locate the range where it may be subject to strong drafts. Any openings in the floor or wall behind the range
should be sealed. Make sure the openings around the base of the range that supply fresh air for combustion and
ventilation are not obstructed by carpeting or woodwork.
Your range, like many other household items, is heavy and can settle into soft floor coverings such as cushioned vinyl
or carpeting. Use care when moving the range on this type of flooring. It is recommended that the following simple and
inexpensive instructions be followed to protect your floor.
The range should be installed on a sheet of plywood (or similar material). When the floor covering ends at the front of
the range, the area that the range will rest on should be built up with plywood to the same level or higher than the floor
covering.
This will allow the range to be moved for cleaning or servicing. Also, make sure your floor covering will withstand 180°F.
(See the Installation Safety Instructions section.)
Hake sure the cabinets and wall coverings around your range can withstand the heat generated (up to 200°F) by the
range. (Seethe Installation Safety Instructions section.)
IMPORTANT!
Remove all tape and packaging. Hake sure the burners are properly seated and level.
Take the accessory pack out of the oven and/or drawer.
Check to be sure that no range parts have come loose during shipping.
CONVERTING TO LP GAS (or converting back
to
natural gas from
LP)
This range leaves the factory set for use with natural gas. If you want to convert to LP gas, the conversion must be
performed by a qualified LP gas installer.
The conversion instructions can be found on back of the range.
Keep these instructions and the orifices in case you want to convert back to natural gas.
The conversion instructions identify where to find the kits on the model. The location is defined in the picture below.
Rear of Range
Orifice Box Location
41