GE Appliances JGB850 Owner's Manual And Installation Instructions page 25

Removeand replace full extension racks, some models GEApp,ancos.
[ CAUTION
Make sure frame is fully inserted in the oven to lock it in place.
Extension
Rack
_ Upper
Front Rail
Fully Open Position
Grasp here
When placing and removing cookware, always
pull the rack out by its upper front rail to its
fully open position.
NOTE: Do not extend the rack quickly. Food
may slide off the front of the rack.
To remove the rack:
[-_ Make sure the rack is pushed all the way into
the oven so that the side paddles on the rack
frame disengages with the oven support.
Firmly grasp the rack handle and pull towards
you .The rack will stop when the curved end of
the rack hits the oven bump.
r3] Tilt the front end up and pull it out.
NOTE: When handling the extension rack, do
not allow the sliding portion to fall open. This
can damage the slides.
To replace the rack:
[7] Firmly grasp both sides of the rack frame
and the sliding rack.
Place the curved end of the rack onto the
desired rack position, tilt up the front of the
rack and push it in as far as it will go.
When the rack is properly installed and locked
into position, the locking side paddles on the
rack frame will click-lock into place on the oven
supports. If the side paddles did not click-lock
into position, repeat the steps above and make
sure the side paddles have been correctly
cleaned and lubricated. See Extension Rack in
the Care and cleaning section.
25