Problem Solving; Troubleshooting - Panasonic Facsimile UF-590 Operating Instructions Manual

Problem Solving

Troubleshooting

If You Have Any of These Problems
Mode Symptom
During Transmission Document doesn't
feed/multiple feed
Document jam
Does not stamp
Stamp too light
Transmission Copy Vertical lines on the
Quality transmitted document
Transmitted document
is blank
During Reception No recording paper
Recording paper jam
Recording paper
doesn't advance into
machine
Recording paper
doesn't eject after
printing
Recording papers are
not stacked in
sequence. Machine
does not print from the
last page received.
Document auto
reduction doesn't work
Out of toner
Continued on the next page...
Cause / Action
1. Check that your document is free of staples and paper
clips, and that it is not greasy or torn.
2. Check that your document is the right type to send through
a fax machine by consulting the list on "Documents You
Cannot Send". If your document has the characteristics
listed, make a photocopy of your document and send the
copy instead.
3. Check that the document is loaded properly.
4. Adjust the ADF Pressure.
The information code 031 will appear on the display if the
document becomes jammed.
1. Check if Stamp LED is lit.
2. Check Fax parameter No. 04 and No. 28 settings.
Replace stamp.
Check own copy quality. If copy is OK, your machine has no
problem, report to the receiving party that they have a
problem. If copy is NG, clean the Document Scanning Area.
1. Make sure the document is set face down.
2. Check own copy quality. If copy is OK, your machine has
no problem, report to the receiving party that they have a
problem. If copy is NG, clean the Document Scanning
Area.
The information code 010 will appear on the display if the
paper runs out.
The information code 001, 002, 007 or 008 will appear on the
display if the paper gets jammed.
Make sure that there is paper in the Paper Cassette. Follow
the instructions for loading paper.
Check to see if the recording paper is jammed inside of the
machine.
1. Check if Fax Parameter No. 65 is set to valid.
2. If memory becomes full during reception, the machine will
start to print from the 1st page received. We recommend
that optional flash memory card is installed if this symptom
occurs frequently.
Check Print Reduction settings.
The information code 041 will appear on the display if the
Toner Cartridge runs out of toner.
page
40
41
140
137
43
36
141
138
138
18
136
18
136
39
147
68
16
129