Installing Or Removing Driver Bit Or Drill Bit; Storage Of Driver Bit; Switch Action; Reversing Switch Action - Makita 6011D Instruction Manual

Installing or removing driver bit or dirll bit
I
CAUTION :
Always be sure that the tool i s switched off and the battery cartridge i s removed before
installing or removing the bit.
Hold the ring and turn the sleeve counter-
clockwise to open the chuck jaws.
Place
the bit in the chuck as far as it will go.
Hold the ring firmly and turn the sleeve
clockwise to tighten the chuck.
To remove the bit, hold the ring and turn
the
sleeve
counterclockwise.
Storage of driver bit
When not using the driver bit, keep it in the storage cavity on the tool.
Switch action
Tool speed
is
increased by increasing pres-
sure on the trigger. To start the tool,
simply pull the trigger. Rlelease the trigger
to stop.
CAUTION :
Before inserting the battery cartridge into the tool, always check to
see that the trigger
switch actuates properly and returns to the "OFF" position when released.
Reversing switch action
This tool has
a
reversing switch to change
the direction -of rotation. Slide the revers-
ing switch to the right for clockwise rota-
tion or to the left for counterclockwise.
Reversing
CAUTION:
Always check the direction of rotation before operation.
*Use the reversing switch only when the tool comes to
a
complete stop. Changing the
direction of rotation before the tool stops may ruin the tool.
7